This polygon shapefile represents geologic features within the offshore area of Bolinas, California. The continental shelf within California's State waters in the Bolinas area is relatively flat (less than 0.3 degrees) and shallow (less than 30 m) in the entire area, however the seafloor of the "Marin shelf" east of the San Andreas Fault (see below) is smooth and covered with sediment, whereas the seafloor of the "Bolinas shelf" west of this fault has extensive bedrock outcrop from the nearshore to depths of about 25 m and much less sediment cover. The morphology and geology of this shelf result from the interplay between local tectonics, sea-level rise, sedimentary processes, and oceanography. Tectonic influences are related to local faulting, folding, uplift, and subsidence (see below). Sea level has risen about 125 to 130 m over about the last 21,000 years (for example, Lambeck and Chappel, 2001; Gornitz, 2009), leading to progressive eastward migration (a few tens of km) of the shoreline and wave-cut platform, and associated transgressive erosion and deposition (for example, Catuneanu, 2006). The Offshore of Bolinas map area is now subjected to full, and sometimes severe, Pacific Ocean wave energy and strong currents. Given their relatively shallow depths and exposure to high wave energy, modern shelf sediments are mostly sand (unit Qms). More coarse-grained sands and gravels (units Qmsc and Qmss) are primarily recognized on the basis of bathymetry and high backscatter (see Bathymetry--Offshore Bolinas, California and Backscattter A to E--Offshore Bolinas, California, DS 781, for more information). Unit Qmsc occurs in two areas, on the east flank of Bolinas shelf bedrock exposures, and as three mounds south of Bolinas near the outer boundary of Californiaâs State Waters at water depths of about 25 m. The largest of these mounds is about 450 m long and 70 m wide, and has 80 cm of positive relief above the seafloor. Unit Qmss is much more extensive and forms erosional lags in rippled scour depressions (for example, Cacchione and others, 1984) that are typically a few tens of centimeters deep and bounded by mobile sand sheets. The depressions occur in four distinct locations. (1) The first location lies adjacent to bedrock outcrops within 2 km of the shoreline south of Double Point (along the western edge of the map area) at water depths of 10 to 25 m. (2) The second unit Qmss location is about 2 to 6 km south of Bolinas Lagoon at similar water depths, along the eastern flank of the Bolinas shelf. (3) The third, more restricted location, occurs about 3 km southeast of Rocky Point at water depths of about 10 to 12 m along the eastern edge of the map area, adjacent to and offshore of small bedrock uplifts. (4) The fourth location, 2 km south of Stinson Beach, is notably different. The polygon on the map encloses a field that includes more than one hundred, much smaller (length less than 20 m) oval depressions and intervening sand flats, perhaps an originally much larger field that has been almost completely filled in by sediment. Similar unit Qmss rippled-scour depressions are common along this stretch of the California coast where offshore sandy sediment can be relatively thin (thus unable to fill the depressions) due to both lack of river input and to significant erosion and transport of sediment during large northwest winter swells. Although the general areas in which both unit Qmss scour depressions and surrounding mobile sand sheets occur are not likely to change substantially, the boundaries of the unit(s) are likely ephemeral, changing seasonally and during significant storm events. Areas where shelf sediments form thin (less than 2.5 m) veneers over low-relief Neogene bedrock (see below) occur in the western half of the map and are mapped as units Qms/Tsc (Santa Cruz Mudstone) and Qms/Tp? (Purisima Formation, queried). These hybrid units are recognized and delineated based on the combination of flat relief, continuity with moderate to high relief onshore or offshore bedrock outcrops, high-resolution seismic-reflection data (see field activities S-8-09-NC and L-1-06-SF), and in some cases moderate to high backscatter. The thin sediment layer is regarded as ephemeral and dynamic, and may or may not be present at a specific location based on storms, seasonal/annual patterns of sediment movement, or longer-term climate cycles. In a nearby, similarly high-energy setting, Storlazzi and others (2011) have described seasonal burial and exhumation of submerged bedrock in northern Monterey Bay. The southeastern corner of the map area includes a portion of the outer flank of the horseshoe-shaped "San Francisco Bar" (unit Qmsb), which has formed at the mouth of the San Francisco ebb-tidal delta (Barnard and others, 2007; Dallas and Barnard, 2011). This delta-mouth bar is shaped by both tidal currents and waves, resulting in a variably hummocky, mottled, and rilled seafloor, and this surface texture is used as a primary criteria for mapping the unit and defining its contacts. Map unit polygons were digitized over underlying 2-meter base layers developed from multibeam bathymetry and backscatter data (see Bathymetry--Offshore Bolinas, California and Backscattter A to E--Offshore Bolinas, California, DS 781, for more information). The bathymetry and backscatter data were collected between 2006 and 2010. This layer is part of USGS Data Series 781.In 2007, the California Ocean Protection Council initiated the California Seafloor Mapping Program (CSMP) to create a comprehensive seafloor map of high-resolution bathymetry, marine benthic habitats and geology within the 3-nautical-mile limit of California's State Waters. CSMP has divided coastal California into 110 map blocks, each to be published individually as United States Geological Survey Open-File Reports (OFRs) or Scientific Investigations Maps (SIMs) at a scale of 1:24,000. Maps display seafloor morphology and character, identify potential marine benthic habitats and illustrate both the seafloor geology and shallow (to about 100 m) subsurface geology. Data layers for bathymetry, bathymetric contours, acoustic backscatter, seafloor character, potential benthic habitat and offshore geology were created for each map block, as well as regional-scale data layers for sediment thickness, depth to transition, transgressive contours, isopachs, predicted distributions of benthic macro-invertebrates and visual observations of benthic habitat from video cruises over the entire state. These data are intended for science researchers, students, policy makers, and the general public. This information is not intended for navigational purposes.The data can be used with geographic information systems (GIS) software to display geologic and oceanographic information. Additionally, this coverage can provide a geologic map for the public and geoscience community to aid in assessments and mitigation of geologic hazards in the coastal region and sufficient geologic information for land-use and land-management decisions both onshore and offshore. This information is not intended for navigational purposes.